Smärtgard Ultra durable floor finish

Helps reduce maintenance without sacrificing shine

Smärtgard is an ultra durable floor finish for concrete floors, marble, terrazzo, sheet vinyl/linoleum, granite, and ceramic and quarry tile. Designed to be stain and dirt resistant, Smärtgard floors are easily cleaned by dusting and wet mopping. It delivers a continuous protection and high-gloss surface and can reduce hard floor maintenance costs as compared to other traditional floor finishes. Less maintenance means you reduce chemicals, electricity, water and floor down time. Those savings help your organization not only lower operations spending but also make environmentally preferable cleaning choices. It is so easy to install, your staff can either apply it themselves or you can contract with your local trained applicators.

Features & Benefits

• Provides ultra durable ‘wet look’ gloss
• Easy to apply
• Easy to maintain—cleans up with dusting or damp mopping
• Designed for improved stain and scuff resistance
• High solids provides superior sheen and resistance to abrasion and scuffing
• Works on multiple substrates: polished concrete, marble, granite, terrazzo, sheet vinyl, VCT tile, ceramic and quarry tile
• Low odor during application and cure
• Zero VOC—Non-flammable, non-combustible, non-corrosive

General Use Directions

• Prior to application, floor should be stripped of previous finishes or deep scrubbed and thoroughly cleaned to remove dirt and debris. Rinse with water until no residue remains and allow floor to dry thoroughly.
• Apply 2-3 light, even coats of Smärtgard floor finish. Do not apply by pouring directly onto the surface; use a plastic roller pan. Apply be synthetic fiber wax applicator or lambs wool applicator.
• Allow at least 60-90 minutes between each coat, depending upon environmental conditions. Apply no more than 4 coats within 24 hours.

 

NOTE:

Heavy coats or inadequate drying time between coats may result in increased stickiness and dirt retention.

After 24 hours, 3-4 additional coats may be applied as desired. Always allow Smärtgard to cure 36-48 hours after application before burnishing.

NOTE:

• Minimum application temperature is 50⁰F.
• Coverage is approximately 500-1000ft²/gallon.
• Full hardness of the finish is achieved in 3-4 days.
• If spray buffing/burnishing immediately, dilute Smärtgard with water @1:2.

technical data
Solids content	28%
Drying time	1-2 hours
Re-Coat Time	2-3 hours
Foot traffic	12-24hours
Wheel Traffic	48 hours
Application Temperature	~500F
Wet Appearance	Milky White
Dry Appearance	Clear
VOC	Zero
Blush resistance	Excellent
Concrete Adhesion	Good