installation instructions —
Self Leveling epoxy
SLE and SLE-T systems

---

Part 1 – Information & Preparation

General Information

Perdüre SLE & SLE-T  are resin flooring systems consisting of 100% solids epoxy resin and aggregates which provide heavy-duty protection at 1/4". When grouted and sealed this flooring system eliminates porosity and produces a dense, skid-inhibiting finish that will minimize dirt and chemical penetration. The chemical resistance and overall performance of Perdüre SLE & SLE-T can be increased by using different epoxy, polyurethane and polyaspartic top coats.

Surface Preparation

Surface Preparation is the most critical portion of any successful resinous flooring system application. All substrates must be properly prepared as outlined in Technical Bulletin-1. Specific attention should be paid to the following:

• Concrete Placement  - An efficient vapor barrier  should be directly under slabs on or below grade to prevent moisture migration
• Curing and Finishing techniques of the concrete substrate
• Age of concrete
• Previous contamination of the substrate
• Present condition of the substrate
• Make sure the floor is free of moisture vapor transmission

Also, the temperature conditions of the area to receive the flooring system should be checked. An optimum room temperature of 75°F with a slab temperature of 50°F is required for proper cure of the resin flooring system.

Material Quantities

Guideline System Requirements for 1000ft2 – 1/16" thick
Perdüre E02	100% solids epoxy primer	4.0 gal
Perdüre E10	100% solids epoxy body coat	22 gal
Filler	Self leveling filler	425 lbs
Perdüre E20a	100% solids epoxy coating	8-10 gal

Perdüre E20 can be replaced with Perdüre U50, Perdüre P70, Perdüre NE25 or Perdüre NE30. Consult your technical representative for suitability of the product.

Guideline System Requirements for 1000ft2 – 1/8" thick BROADCAST SYSTEM
Perdüre E02	100% solids epoxy primer	4.0 gal
Perdüre E10	100% solids epoxy body coat	22 gal
Filler	Self leveling filler	425 lbs
Sand	Broad cast sand, #30 mesh	500 lbs
Perdüre E20a	100% solids epoxy coating	8-10 gal
Perdüre U50	Solvent based polyurethane	3-4 gal

Perdüre E20 can be replaced with Perdüre U50, Perdüre P70, Perdüre NE25 or Perdüre NE30. Consult your technical representative for suitability of the product.

Recommended Batch Quantities

• 1.25 gal unit of Perdüre E10
• 25 lbs of Self-leveling filler

Estimated batch coverage: - 60 ft²

Page 1 of 4 >>