How to install Endura high performance grade III resin chip system Link to Contact Page

installation instructions —
Epoxy, Polyurethane, Acrylic and Polyaspartic Coatings

PDF DocumentDownload these Installation Instructions

Part 8 – Application Perdüre A01 &A03

Perdüre A01 - Acrylic Sealer (Clear, Gloss)

Mixing

  1. Perdüre A01 is a single component solvent based acrylic, mix for two-three minutes with a low speed electric drill mixing paddle.

Application

  1. Pour material into a paint pan, apply with 1/4"-3/8" nap roller using "dip and roll" technique at 250-500 ft² per gallon. Re-coat time is 2-4 hours at 75°F. Apply one or two coats as required to achieve desired finish.
  2. Do not open to light foot traffic for 24 hours (at 75°F). Vehicle traffic in 48 hours. Full chemical cure and maximum chemical resistance are achieved in 5 days.
<hr /> duraamen rule image

Perdüre A03 - Acrylic Sealer (Clear, Gloss)

Mixing

  1. Perdüre A03 is a single component water based acrylic, mix for two-three minutes with a low speed electric drill mixing paddle.

Application

  1. Pour material into a paint pan, apply with 1/4"-3/8" nap roller using "dip and roll" technique, lamb's wool applicator, or spray with low pressure pump at 300-400 ft² per gallon. Re-coat time is 1 hour at 75 degrees F. Good air movement and humidity control are necessary for proper drying with water based sealers. Apply one or two coats as required to achieve desired finish.
  2. Do not open to light foot traffic for 24 hours (at 75°F). Vehicle traffic in 48 hours. Full chemical cure and maximum chemical resistance are achieved in 5 days.

<< Page 8 of 8