installation instructions —
Endüra high performance grade III resin chip system

---

Part 1 – Information & Preparation

General Information

Endüra is high performance decorative resin chip system consisting of 100% solids epoxy resin and colored resin chips. Endüra flooring system is finished with clear catalyst-cured coats of resin available in a satin or gloss finish. The installed system can be textured or smooth as desired. Endüra flooring system, is typically recommended in garage floors, basement floors, workshop floors, laundry room floors, locker room floors, restaurants, food service areas, hospitals and fire stations.

Surface Preparation

Surface Preparation is the most critical portion of any successful resinous flooring system application. All substrates must be properly prepared as outlined in Technical Bulletin -1. Specific attention should be paid to the following:

• Concrete Placement  - An efficient vapor barrier  should be directly under slabs on or below grade to prevent moisture migration
• Curing and Finishing techniques of the concrete substrate
• Age of concrete
• Previous contamination of the substrate
• Present condition of the substrate
• Make sure the floor is free of moisture vapor transmission

Also, the temperature conditions of the area to receive the flooring system should be checked. An optimum room temperature of 75°F with a slab temperature of 50°F is required for proper cure of the resin flooring system.

Material Quantities

Guideline System Requirements for 1000ft2
Endüra E02a	100% solids epoxy primer	4.0 gal
Endüra E21	100% solids epoxy body coat	6.0 gal
Resin Chips	For full broadcast	55-70 lbs
Endüra P70b	100% solids polyaspartic clear coat	4.0 gal
Additive	Non-skid additive, fine or coarse	Varies

The application of primer Endüra E02 is optional

Instead of Endüra P70, One coat of Endüra E12 and one coat of Endüra U50 can be used

Page 1 of 4 >>